Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition On
- Verify that DTC P0412, P0418, P041F, P044F, P2257, P2258, P2432 or P2433 is not set.
- If any of the DTCs are set
Refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- If none of the DTCs are set.
- If any of the DTCs are set
- Verify the G21 Secondary Air Injection Pump turns On and Off when commanding the Secondary Air Injection Pump Relay On and Off with a scan tool.
- If the pump does not turn On and Off
Refer to Circuit/System Testing
- If the pump turns On and Off
- If the pump does not turn On and Off
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- Verify the DTC does not set.
- If the DTC sets
Refer to Circuit/System Testing
- If the DTC does not set
- If the DTC sets
- All OK
NOTE:
To prevent the secondary air injection pump from overheating, do not operate the pump consecutively for greater than 2 minutes. The pump is provided with a thermal protector that will automatically reset when allowed to cool.