Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

DTCs P0016, P0017, P0030, P0036, P0053, P0054, P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0116, P0117, P0118, P0019, P0122, P0123, P0128, P0131-P0135, P0137, P0138, P013A, P013B, P013E, P013F, P0140, P0141, P0171, P0172, P0201-P0204, P0222, P0223, P0261, P0262, P0264, P0265, P0267, P0268, P0270, P0271, P0300, P0301-P0304, P0340, P0341, P0365, P0366, P0411, P0442, P0455, P0458, P0496, P111E, P1133, P1248, P1249, P124A, P124B, P16A0, P16A1, P16A2, P16F3, P2101, P2135, P2147, P2148, P2150. P2151, P2153, P2154, P2156, P2157, P2270, P2271, P2440, P2444 or P2A00 are not set.
The evaporative emission system device control and intrusive diagnostics are not active.
The engine overspeed protection is not active.
The engine is in closed loop status.
The system voltage is greater than 11V.
The engine coolant temperature (ECT) is warmer than -20°C (-4°F).
The engine speed is between 1,200-4,000 RPM.
The mass air flow is between 0-100g/s.
The secondary air injection pump (if equipped) is not ON.
The Exhaust Camshaft Position and Intake Camshaft Position are between 0-35 degrees.
Engine run time is greater than 30s.
Fuel level is greater than 10% and no fuel level sensor fault is present.
The DTC runs continuously when the above conditions have been met.