Repair Verification
WARNING: This page is about a different variant/trim than selected.
- Install any components that have been removed or replaced during diagnosis.
- Perform any adjustments, programming or setup procedures that are required when a component is removed or replaced.
- Clear the DTCs with a scan tool.
- Ignition OFF and all vehicle systems OFF. It may take up to 2 minutes for all vehicle systems to power down.
- Ignition ON.
- Verify the scan tool TAC Motor parameter displays Enabled while performing the Throttle Sweep Test with a scan tool.
- If Disabled
Test or replace the Q38 Throttle Body.
- If Enabled
- If Disabled
- If the repair was related to a DTC, duplicate the Conditions for Running the DTC and use the Freeze Frame/Failure Records, if applicable, in order to verify the DTC does not set.
- If DTC sets
Refer to Diagnostic Trouble Code (DTC) List - Vehicle for further diagnosis.
- If DTC does not set
- If DTC sets
- All OK