Conditions for Setting the DTC
WARNING: This page is about a different variant/trim than selected.
P0685
The ECM detects that the commanded state of the driver and the actual state of the control circuit do not match for greater than 2s.
P0686
The ECM detects a short to ground on the control circuit for greater than 2 s.
P0687
The ECM detects a short to voltage on the control circuit for greater than 2 s.
P0689
The engine controls ignition relay voltage is less than 5 volts for greater than 5s.
P0690
The ECM detects the engine controls ignition relay feedback circuit is greater than 4V for greater than 5s.
P1682
The ECM detects that there is greater than 3V difference between the ignition main relay signal and the engine controls ignition relay signal circuits for greater than 1s.