LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2015 >> Regal GS, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Engine Controls And Fuel - 2.4L - DTC P0114 To DTC P0604) >> Diagnostic Information and Procedures >> DTC P0455: Evaporative Emission (EVAP) System Large Leak >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different variant/trim than selected.
NOTE:
  • Larger volume fuel tanks and/or those with lower fuel levels may require several minutes for the floating indicator to stabilize or produce smoke from a leak.
  • Refer to the GE-41413-A  operation manual for detailed instructions in Evaporative Emission Control System Diagnosis .
  1. Disconnect the purge tube at the quick connector on the EVAP canister side of the Q12 Evaporative Emission Purge Solenoid Valve and install the CH-48096  .
  2. Connect the GE-41413-A  to the vehicle EVAP service port adapter.
  3. Command the EVAP Purge/Seal function to Not Venting with a scan tool to seal the EVAP system.
  4. Verify that there is no leak in the EVAP system using the flow meter on the GE-41413-A  , calibrated to 0.51mm (0.020in).
    • If a leak is detected 
    1. Apply smoke to the EVAP system at the service access port adapter with the GE-41413-A  .
    2. Locate the leak using the GE-41413-SPT  .
      • When the leak is located, repair or replace the affected component as necessary.
    • If no leak detected 
      NOTE:

      The steps below test for a restriction in the purge path.

  5. Connect the GE-41413-A  nitrogen/smoke hose to the J-41413-311  .
  6. Disconnect the hose at the fuel cap end of the GE-41415-30  and connect to the J-41413-311  .
  7. Install the GE-41415-30  , filler neck end only, to the vehicle.
  8. Engine idling, command the Purge/Seal function to Not Venting with a scan tool to seal the system.
  9. Command the EVAP Purge Solenoid Valve to 30% with a scan tool.
  10. Verify the vacuum/pressure gauge on the GE-41413-A  and the scan tool Fuel Tank Pressure Sensor parameter both show vacuum.
    • If the vacuum/pressure gauge shows vacuum, and the Fuel Tank Pressure Sensor parameter does not show vacuum 

      Replace the B150 Fuel Tank Pressure Sensor.

    • If both do not show vacuum 

      Repair the restriction in the purge path.

    • If both show vacuum 
  11. Verify that the Fuel Tank Pressure Sensor parameter increases to greater than 3.2V, and the pressure values are similar between the scan tool Fuel Tank Pressure Sensor and the vacuum/pressure gauge on the GE-41413-A  .
    • If not within the specified range 

      Replace the B150 Fuel Tank Pressure Sensor.

    • If within the specified range 
  12. All OK
scientia non olet · About LEMON Manuals