LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2015 >> Regal GS, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Engine Controls And Fuel - 2.4L - DTC P0114 To DTC P0604) >> Diagnostic Information and Procedures >> DTC P0442: Evaporative Emission (EVAP) System Small Leak >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different variant/trim than selected.
NOTE:
  • Refer to the GE41413-A  operation manual for detailed instructions in Evaporative Emission Control System Diagnosis .
  • Larger volume fuel tanks and/or those with lower fuel levels may require several minutes for the floating indicator to stabilize or produce smoke from a leak.
  • Ensure that the underbody temperature of the vehicle and the tester are similar.
  1. Disconnect the purge tube at the quick connector on the EVAP canister side of the Q12 Evaporative Emission Canister Purge Solenoid Valve and install the CH48096  .
  2. Connect the GE41413-A  to the CH48096  .
  3. Command the EVAP Purge/Seal function to System Seal with a scan tool to seal the EVAP system.
  4. Use the flow meter on the GE41413-A  calibrated to 0.51mm (0.020in) to determine if there is a leak.
    • If a leak is detected 
    1. Use the GE41413-A  to apply smoke to the EVAP system at the purge tube service port until the leak is located using the GE41413-SPT  .
      • If leak is detected, repair or replace the affected component as necessary.
    • If no leak is detected 
  5. All OK.
scientia non olet · About LEMON Manuals