LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2015 >> Regal GS, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Engine Controls And Fuel - 2.4L - DTC P0114 To DTC P0604) >> Diagnostic Information and Procedures >> DTC P0340, P0341, P0365, or P0366: Intake/Exhaust Camshaft Position Sensor >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Ignition ON.
  2. Verify DTC P0641 or P0651 is not set.
    • If none of the DTCs are set 
  3. Engine running.
  4. Verify the scan tool parameters listed below increment:
    • Exhaust Camshaft Position Active Counter
    • Intake Camshaft Position Active Counter
    • If any counter does not increment 

      Refer to Circuit/System Testing.

    • If all counters increment 
  5. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
  6. Verify the DTC does not set.
    • If the DTC sets 

      Refer to Circuit/System Testing.

    • If the DTC does not set 
  7. All OK.
scientia non olet · About LEMON Manuals