LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2015 >> Regal GS, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 2.4L) >> Repair Instructions - On Vehicle >> Camshaft Cover Replacement (LUK) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Camshaft Cover And Gasket
    GM2680257Courtesy of GENERAL MOTORS COMPANY
  1. Assemble the camshaft cover (1) and a NEW gasket (2). Ensure that the gasket is located in the retaining groove in the camshaft cover.
    2. Fig 2: Camshaft Cover Bolt
    GM2680258Courtesy of GENERAL MOTORS COMPANY
  2. Install NEW camshaft cover grommets and camshaft cover bolts (1).
  3. Install the cover on the cylinder head and hand start the bolts. Tighten the bolts to 10 N.m (89 lb in).
    4. Fig 3: Camshaft Housing Cover Insulator
    GM2207000Courtesy of GENERAL MOTORS COMPANY
  4. Install the camshaft housing cover insulator (1). Tighten the bolts to 10 N.m (89 lb in).
    5. Fig 4: Front Lift Bracket
    GM2206998Courtesy of GENERAL MOTORS COMPANY
  5. Install the front lift bracket (1).
  6. Install the front lift bracket bolts and tighten to 25 N.m (18 lb ft).
    7. Fig 5: Rear Lift Bracket
    GM2206997Courtesy of GENERAL MOTORS COMPANY
  7. Install the rear lift bracket (1).
  8. Install the rear lift bracket bolts and tighten to 25 N.m (18 lb ft).
    9. Fig 6: Evaporative Emission Canister Purge Tube
    GM2680256Courtesy of GENERAL MOTORS COMPANY
  9. Install the evaporative emission canister purge tube (1). Refer to Plastic Collar Quick Connect Fitting Service .
  10. connect the fuel like clip.
  11. install the ignition coils. Refer to Ignition Coil Replacement Ignition Coil Replacement.
  12. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement Air Cleaner Outlet Duct Replacement.
scientia non olet · About LEMON Manuals