LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2015 >> Regal GS, AWD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 2.0L (LTG) - Repair Instructions - On Vehicle >> Repair Instructions - On Vehicle >> Crankshaft Balancer Replacement >> Removal Procedure

Removal Procedure

  1. Remove the drive belt. Refer to Drive Belt Replacement .
    2. Fig 1: Crankshaft Balancer Remover
    GM3971349Courtesy of GENERAL MOTORS COMPANY
  2. Use EN-51577-1   Crankshaft Balancer Remover (1) and ratchet (2) prevent the crankshaft from rotating while loosening the crankshaft balancer fastener (3).
  3. Remove and DISCARD the crankshaft balancer fastener (3).
    4. Fig 2: Crankshaft End Protector
    GM3971443Courtesy of GENERAL MOTORS COMPANY
  4. Remove the crankshaft balancer holder then install the EN-51577-1  Crankshaft End Protector (1) and all components of EN-51577-1  Crankshaft Balancer Remover (2,3) as shown.
    5. Fig 3: Crankshaft Balancer Remover
    GM3971380Courtesy of GENERAL MOTORS COMPANY
  5. Tighten the crankshaft balancer remover (1) in order to remove the crankshaft balancer (2).
scientia non olet · About LEMON Manuals