LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2015 >> Regal GS, AWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brake System >> Repair Instructions >> Brake and Accelerator Pedal Assembly Replacement >> Removal Procedure

Removal Procedure

  1. Remove the instrument panel tie bar. Refer to Instrument Panel Tie Bar Replacement
  2. Disconnect the accelerator pedal position sensor electrical connector.
  3. Remove the brake pedal position sensor. Refer to Brake Pedal Position Sensor Replacement
    4. Fig 1: Brake Pedal
    GM2347572Courtesy of GENERAL MOTORS COMPANY
  4. Pull the brake pedal (1) rearward to release the power vacuum brake booster pushrod retainer.
    5. NOTE:

    Do not reuse the power vacuum brake booster pushrod retainer.

  5. Remove and discard the power vacuum brake booster pushrod retainer.
  6. Remove the power vacuum brake booster. Refer to Power Vacuum Brake Booster Replacement 
    7. Fig 2: Brake Pedal Assembly And Nuts
    GM2347575Courtesy of GENERAL MOTORS COMPANY
  7. Remove the brake pedal assembly nuts (1) .
  8. Remove the brake pedal assembly.
scientia non olet · About LEMON Manuals