LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2015 >> Regal GS, AWD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Fuel Tank Filler Pipe Housing Replacement >> Removal Procedure

Removal Procedure

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the right rear wheel. Refer to Tire and Wheel Removal and Installation .
  3. Remove the rear wheelhouse panel liner. Refer to Rear Wheelhouse Liner Replacement .
    4. Fig 1: Fuel Tank Filler Pipe, Housing & Door Lock Actuator Wiring Harness Electrical Connector
    GM2020140Courtesy of GENERAL MOTORS COMPANY
  4. Disconnect the fuel tank filler door lock actuator wiring harness electrical connector (1).
  5. Remove fuel tank filler pipe fastener (2).
  6. Remove the fuel tank filler pipe from fuel tank filler pipe housing (3).
    7. Fig 2: Fuel Tank Filler Pipe Housing
    GM2020144Courtesy of GENERAL MOTORS COMPANY
  7. Remove the fuel tank filler pipe housing (1) from the body side outer panel by depressing in on the far retainer tab on the backside of the fuel tank filler pipe housing.
scientia non olet · About LEMON Manuals