Driver or Passenger Seat Adjuster Finish Cover Replacement (8-Way-Power)
Courtesy of GENERAL MOTORS COMPANY Driver or Passenger Seat Adjuster Finish Cover Replacement (8-Way-Power)
| Callout |
Component Name |
|
Preliminary Procedures
- Open the front door.
- Release the driver seat retractor side belt.
- Remove the driver or passenger seat. Refer to Driver or Passenger Seat Replacement (Oshawa 2/4/6-Way Hybrid, 6-Way Sport) .
- Remove the front seat adjuster and recliner knob.
Use a small flat-bladed tool to unclip the adjuster and recliner knob.
|
| 1 |
Front Seat Adjuster Finish Cover Retainer |
| 2 |
Front Seat Adjuster Finish Cover Fastener |
| 3 |
Front Seat Adjuster Finish Cover Retainer Procedure
- Disengage front retainer.
- Pull up on the front of cover to disengage the front hook.
- Carefully pull up on the center of the cover to disengage the center hook.
|
| 4 |
Front Seat Adjuster Finish Cover Procedure
- Disconnect the electrical connector.
- Disengage and remove the remainder of the finish cover by pulling the cover upward and outboard away from the seat.
NOTE:
When reinstalling the finish cover, re-snap the front retainer together around the finish cover retainer rod.
|