LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2011 >> Enclave CX, FWD >> Repair and Diagnosis >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling System >> Repair Instructions >> Radiator Replacement (Enclave)

Radiator Replacement (Enclave)

Fig 1: Radiator (Enclave)
GM1864161Courtesy of GENERAL MOTORS CORP.
Radiator Replacement (Enclave)

Callout Component Name

Preliminary Procedure

  1. Drain the coolant. Refer to Cooling System Draining and Filling (Static Fill) , Cooling System Draining and Filling (Vac N Fill) 
  2. Remove radiator inlet hose. Refer to Radiator Inlet Hose Replacement .
  3. Remove radiator outlet hose. Refer to Radiator Outlet Hose Replacement .
  4. Remove fan shroud top mounting bolts and pushpin from radiator and position fan shroud rearward. Refer to Cooling Fan and Shroud Replacement .
  5. Remove transmission inlet cooling line from radiator. Refer to Fluid Cooler Inlet Hose Replacement .
  6. Remove transmission outlet cooling line from radiator. Refer to Fluid Cooler Outlet Hose Replacement .
  7. Remove coolant reservoir hose from radiator filler neck.
  8. Pinch fastening tabs together at top of condenser to remove from radiator and position forward.
  9. Remove side rubber air deflectors from radiator tanks.
1 Radiator Mounting Bolt (Qty: 2)
CAUTION:

Refer to Fastener Caution .


Tighten 
10 N.m (89 lb in)
2 Radiator
  • Bottom of condenser mounts into holding fixtures at bottom of radiator.
  • Radiator will slide out between the condenser and fan shroud.
scientia non olet · About LEMON Manuals