LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2011 >> Enclave CX, FWD >> Repair and Diagnosis >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling System >> Repair Instructions >> Cooling Fan and Shroud Replacement

Cooling Fan and Shroud Replacement

Fig 1: View Of Cooling Fan & Shroud
GM1864152Courtesy of GENERAL MOTORS CORP.
Cooling Fan and Shroud Replacement

Callout Component Name

Preliminary Procedure

  1. Remove front bumper impact bar. Refer to Front Bumper Impact Bar Replacement .
  2. Remove radiator inlet hose at radiator. Refer to Radiator Inlet Hose Replacement .
  3. Disconnect electrical connector at fan shroud harness.
  4. Remove front fascia upper support. Refer to Front Bumper Fascia Upper Support Replacement (Enclave) , Front Bumper Fascia Upper Support Replacement (Acadia and Traverse) .
  5. Remove hood latch. Refer to Hood Primary and Secondary Latch Replacement .
  6. Remove upper radiator mounting brackets and tip radiator forward for additional clearance.
1 Fan Shroud Mounting Bolt (Qty: 2)
CAUTION:

Refer to Fastener Caution .


Procedure 
Remove small pushpin retainers.
Tighten 
10 N.m (89 lb in)
2 Fan Shroud
Procedure 
Tilt fan shroud rearward and upward to remove.
TIP:  Reposition of radiator hoses my be necessary for removal.
scientia non olet · About LEMON Manuals