Installation Procedure

WARNING: This page is about a different variant/trim than selected.

If necessary, perform the following steps:
- Assemble the cylinder head. Refer to Cylinder Head Assemble .
- Install the exhaust manifold to the cylinder head. Refer to Exhaust Manifold Installation - Left Side .

Fig 1: View Of Right Cylinder Head Gasket

Courtesy of GENERAL MOTORS CORP.

Fig 2: View Of Right Cylinder Head

Courtesy of GENERAL MOTORS CORP.

Carefully install the cylinder head with the exhaust manifold to the engine. Refer to Cylinder Head Installation - Left Side .
Connect the catalytic converter to the exhaust manifold.
Install the battery negative cable to the cylinder head. Refer to Battery Negative Cable Replacement (LY7) .

Fig 3: Locating Engine Wiring Harness Bracket Bolt & Engine Wiring Harness Bracket Stud

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the wiring harness conduit to the cylinder head.
Tighten: Tighten the wiring harness upper bolt to 10 N.m (89 lb in).

Fig 4: View Of Wiring Harness Ground Bolt At Side Of Right Cylinder Head

Courtesy of GENERAL MOTORS CORP.

Install the wiring harness ground to the side of the cylinder head.
Tighten: Tighten the wiring harness ground bolt to 10 N.m (89 lb in).
Install the catalytic converter. Refer to Catalytic Converter Replacement .
Install the coolant inlet pipe.
Tighten:
- Tighten the coolant inlet pipe-to-cylinder head bolt to 50 N.m (37 lb ft).
- Tighten the coolant inlet pipe-to-thermostat housing bolt to 10 N.m (89 lb in).
Install the right bank secondary timing chain. Refer to Secondary Camshaft Drive Chain Replacement - Right Side .