LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2008 >> Allure CXL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System & Fuel System - 3.6L - Introduction (2 Of 2)) >> Repair Instructions >> Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 2 (Left Side) Intake >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition OFF.
    2. IMPORTANT: Do not disconnect the power steering fluid lines/hoses from the reservoir.
  2. Remove the power steering fluid reservoir bolts and reposition the power steering fluid reservoir in order to provide access. Refer to Remote Power Steering Fluid Reservoir Replacement (LY7) .
    3. Fig 1: View Of Left CMP Actuator Valve Electrical Connector - Intake
    GM1285232Courtesy of GENERAL MOTORS CORP.
  3. Remove the camshaft position (CMP) actuator valve electrical connector.
    4. Fig 2: View Of Left CMP Actuator Valve - Intake
    GM1285234Courtesy of GENERAL MOTORS CORP.
  4. Remove the CMP actuator valve bolt.
  5. Remove the CMP actuator valve.
scientia non olet · About LEMON Manuals