LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Mechanical - 4.6L (2 Of 5)) >> On-Vehicle Repair Instructions (1 Of 2) >> Engine Support Fixture >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Lift Hook (J 28467-7A)
    GM1660451Courtesy of GENERAL MOTORS CORP.
  1. Remove the J 28467-7A lift hook from the engine mount strut bracket.
  2. Remove the J 28467-B  .
  3. Remove the J 28467-501  .
    4. Fig 2: Identifying Engine Mount Strut Bolt
    GM1660428Courtesy of GENERAL MOTORS CORP.
  4. Install the engine mount strut.
    5. NOTE: Refer to Fastener Notice .
  5. Install the engine mount strut bolt.

    Tighten:  Tighten the bolt to 70 N.m (52 lb ft).

    6. Fig 3: Identifying engine mount strut nut
    GM1754010Courtesy of GENERAL MOTORS CORP.
  6. Install the engine mount strut nut.

    Tighten:  Tighten the nut to 70 N.m (52 lb ft).

    7. Fig 4: Identifying Surge Tank
    GM1660422Courtesy of GENERAL MOTORS CORP.
  7. Position the surge tank to the studs.
  8. Install the surge tank nuts and push pin retainer.

    Tighten:  Tighten the nuts to 6 N.m (53 lb in).

  9. Install the front compartment sight shield. Refer to Front Compartment Sight Shields Replacement .
  10. Install the air inlet grille. Refer to Air Inlet Grille Panel Replacement .
scientia non olet · About LEMON Manuals