LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 50 (Seat Belt System) >> Repair Instructions >> Child Restraint Tether Anchor Replacement

Child Restraint Tether Anchor Replacement

WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.

Removal Procedure

    Fig 1: View Of Child Restraint Tether Brackets
    GM604202Courtesy of GENERAL MOTORS CORP.

  1. Remove the rear shelf trim panel. Refer to Trim Panel Replacement - Rear Window Shelf in Interior Trim.

  2. Slide the sound barrier out from under the upper quarter panel trim.
  3. Pull the sound barrier forward to access the tether bolts.
  4. Remove the child seat tether bracket to rear shelf bolts.
  5. Remove the child seat tether brackets from the rear shelf.

Installation Procedure

    Fig 2: View Of Child Restraint Tether Brackets
    GM604202Courtesy of GENERAL MOTORS CORP.
  1. Install the child seat tether brackets to the slots in the rear shelf.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the child seat tether bracket to rear shelf bolts.

    Tighten:  Tighten the child seat tether bracket to rear shelf bolts to 20 N.m (15 lb ft).

  3. Push the sound barrier back into its original position.
  4. Install the rear shelf trim panel. Refer to Trim Panel Replacement - Rear Window Shelf in Interior Trim.
scientia non olet · About LEMON Manuals