Trim Panel Replacement - Rear Window Shelf
WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
Courtesy of GENERAL MOTORS CORP. Trim Panel Replacement - Rear Window Shelf
| Callout |
Component Name |
| Fastener Tightening Specifications:
Refer to Fastener Tightening Specifications . |
Preliminary Procedure
- Remove the rear seat cushion. Refer to Seat Cushion Replacement - Rear
.
- Remove the rear seat back. Refer to Seat Back Replacement - Rear (Non-folding)
or Seat Back Replacement - Rear (Folding)
.
- Remove the rear upper quarter trim panel. Refer to Trim Panel Replacement - Rear Quarter Upper .
|
| 1 |
Retainer, Rear Window Panel Trim (Qty: X) |
| 2 |
Trim Assembly, Rear Window Panel
Tip:
- Lift the panel and remove the outside seat belts through the slots in the trim panel.
- Lift the panel and remove the center seat belt escutcheon, then pass it and the center seat belt through the slot in the trim panel.
- Slide the panel forward to disengage the integral hook from the retaining hole.
- Disconnect the electrical connector from the high mount stop lamp.
|