Heated Seat Always On
WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
Heated Seat Always On
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Driver Seat Schematics or Passenger Seat Schematics Connector End View Reference: Power Seat Systems Connector End Views or Master Electrical Component List in Wiring Systems |
|||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
| 2 | Verify that the Heated Seat Always On complaint is present. Does the heated seat system operate as described in the system description and operation? |
Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
| 3 |
|
Go to Step 6 | Go to Step 4 |
| 4 |
|
Go to Step 7 | Go to Step 5 |
| 5 | Inspect for poor connections at the harness connector of the heated seat relay. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 10 | Go to Step 8 |
| 6 | Inspect for poor connections at the harness connector of the HVAC control module. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 10 | Go to Step 9 |
| 7 | Repair the short to battery positive voltage in the heated seat element supply voltage circuit of the seat heating elements. Refer to Wiring Repairs
in Wiring Systems. Did you complete the repair? |
Go to Step 10 | - |
| 8 | Replace the heated seat relay. Refer to Relay Replacement (Within an Electrical Center)
or Relay Replacement (Attached to Wire Harness)
in Wiring Systems. Did you complete replacement? |
Go to Step 10 | - |
| 9 | Replace the HVAC control module. Refer to Control Module References
in Computer/Integrating Systems for replacement, setup and programming. Did you complete the replacement? |
Go to Step 10 | - |
| 10 | Operate the system in order to verify the repair Did you correct the condition? |
System OK | Go to Step 2 |