LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 222 (Heating, Ventilation And Air Conditioning) >> Repair Instructions >> Blower Motor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Blower Motor & Components
    GM1547642Courtesy of GENERAL MOTORS CORP.
  1. Install the blower motor (2).
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the blower motor screws (1).

    Tighten:  Tighten the screws to 1.2 N.m (11 lb in).

    3. Fig 2: Identifying Blower Motor Electrical Connector
    GM1547641Courtesy of GENERAL MOTORS CORP.
  3. Connect the blower motor electrical connector (1).
  4. Install the right side I/P insulator. Refer to Knee Bolster, Insulator, Molding Replacement - Instrument Panel in Instrument Panel, Gages and Console.
scientia non olet · About LEMON Manuals