Knee Bolster, Insulator, Molding Replacement - Instrument Panel

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Instrument Panel Knee Bolster, Insulator & Molding

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
NOTE: Refer to Fastener Notice . Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .
Instrument Panel (I/P) Insulator Panel Replacement
1	Retainer, I/P Insulator Panel (Qty: 3)
2	Panel, I/P Insulator RH
I/P Lower Molding Replacement
3	Molding Assembly, I/P Lower Trim
4	Clip, I/P Lower Molding (Qty: 3)
I/P Steering Column Opening LH Inboard Molding Replacement
5	Molding Assembly, I/P Steering Column Opening LH Inboard
6	Clip, I/P Steering Column Opening (Qty: 2)
I/P Steering Column Opening LH Molding Replacement
7	Molding Assembly, I/P Steering Column Opening LH
8	Clip, I/P Steering Column Opening (Qty: 2)
I/P Insulator Panel Replacement
9	Retainer, I/P Insulator Panel (Qty: 2)
10	Panel, I/P Insulator LH
I/P Driver Knee Bolster Replacement
11	Screw, I/P Driver Knee Bolster (Qty: 3) Tighten: 2 N.m (18 lb in)
12	Bolster Assembly, I/P Driver Knee
13	Clip, I/P Driver Knee Bolster (Qty: 4)