Removal Procedure
WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the driver side knee bolster. Refer to Knee Bolster, Insulator, Molding Replacement - Instrument Panel in Instrument Panel, Gages and Console.
- Locate the mode actuator (4).
- Disconnect the mode actuator electrical connector (3).
- Remove the mode actuator bolts/screws (1).
- Remove the mode actuator (2).