LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 221 (HVAC Systems - Manual) >> Repair Instructions >> Air Temperature Actuator Replacement (Single Zone) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Air Temperature Actuator (Single Zone)
    GM1548532Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The actuator lever can only be inserted into the door one way.
  1. Install the air temperature actuator lever (3), if necessary.
  2. Install the air temperature actuator (2).
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the air temperature actuator bolts/screws (1).

    Tighten:  Tighten the bolts/screws to 1.2 N.m (11 lb in).

    4. Fig 2: Identifying Air Temperature Actuator Componrnts (Single Zone)
    GM1548556Courtesy of GENERAL MOTORS CORP.
  4. Connect the air temperature actuator electrical connector (7).
  5. Install the driver side knee bolster. Refer to Knee Bolster, Insulator, Molding Replacement - Instrument Panel in Instrument Panel, Gages and Console.
  6. Re-calibrate the actuators. Refer to Re-Calibrating Actuators .
scientia non olet · About LEMON Manuals