LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 212 (Parking Brake System) >> Repair Instructions >> Park Brake Cable Replacement - Front >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the left-side instrument panel insulator. Refer to Knee Bolster, Insulator, Molding Replacement - Instrument Panel in Instrument Panel, Gages and Console.
  2. Remove the left-side carpet retainer. Refer to Door Sill Plate Replacement (Door) or Door Sill Plate Replacement (Sliding Door) in Interior Trim.
  3. Fold back the carpet for access.
  4. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
    5. Fig 1: Adjusting Park Brake Tension At Equalizer Assembly
    GM732929Courtesy of GENERAL MOTORS CORP.
  5. Loosen the park brake cable equalizer nut in order to remove the park brake cable from the park brake cable connector.
    6. Fig 2: Locating Park Brake Cable Connector
    GM474297Courtesy of GENERAL MOTORS CORP.
  6. Remove the park brake cable end from the park brake cable connector.
  7. Remove the park brake cable from all cable retainers.
  8. Lower the vehicle.
    9. Fig 3: View Of Park Brake Cable End
    GM177096Courtesy of GENERAL MOTORS CORP.
  9. Remove the park brake cable end from the park brake lever clevis.
    10. Fig 4: Removing Cable From Lever
    GM177173Courtesy of GENERAL MOTORS CORP.
  10. Use the J 37043  in order to remove the cable from the lever. See Special Tools .
  11. Remove the front park brake cable from the vehicle.
scientia non olet · About LEMON Manuals