LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 207 (Automatic Transaxle - 4T65-E - Introduction (2 Of 2)) >> Repair Instructions >> Automatic Transmission Range Selector Cable Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the throttle body air inlet duct. Refer to Air Cleaner Intake Duct Replacement in Engine Controls - 3.5L (LX9).
    2. Fig 1: Identifying Automatic Transmission Range Selector Cable
    GM1544831Courtesy of GENERAL MOTORS CORP.
  2. Use a flat-bladed tool in order to remove the retaining clip (2) from the automatic transaxle range selector cable (3).
  3. Use a large flat-bladed tool in order to remove the automatic transaxle range selector cable (1) from the cable lever (5).
  4. Use pliers in order to depress the cable retainers.
  5. Remove the automatic transaxle range selector cable from the automatic transaxle range selector cable bracket (4).
  6. Remove the knee bolster. Refer to Knee Bolster, Insulator, Molding Replacement - Instrument Panel in Instrument Panel, Gages and Console.
    7. Fig 2: Identifying Range Selector Cable Retaining Clip
    GM1539229Courtesy of GENERAL MOTORS CORP.
  7. Remove the retaining clip (4) from the automatic transaxle range selector cable (3).
  8. Remove the automatic transaxle range selector cable (2) from the column control lever (1).
  9. Remove the automatic transaxle range selector cable from the steering column bracket (5).
    10. Fig 3: View Of Automatic Transaxle Range Selector Cable In The Cowl
    GM161138Courtesy of GENERAL MOTORS CORP.
  10. Remove the automatic transaxle range selector cable through the hole in the cowl.
scientia non olet · About LEMON Manuals