LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 186 (Engine Controls - 3.9L - Introduction (2 Of 2)) >> Repair Instructions >> Accelerator Pedal with Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Disconnecting Accelerator Pedal Position Sensor Electrical Connector
    GM1544734Courtesy of GENERAL MOTORS CORP.
  1. Install the accelerator assembly (2) to the vehicle.
    2. NOTE: Refer to Fastener Notice .
  2. Install the accelerator mounting bolts (1) to the accelerator bracket.

    Tighten:  Tighten the accelerator pedal nuts to 10 N.m (89 lb in).

  3. Connect the accelerator pedal position sensor electrical connector.
  4. Confirm that the accelerator sensor CPA clip is fully secured.
  5. Install the insulator panel. Refer to Knee Bolster, Insulator, Molding Replacement - Instrument Panel .
  6. Verify the operation of the accelerator pedal.
scientia non olet · About LEMON Manuals