LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 185 (Engine Controls - 3.5L - Introduction (2 Of 2)) >> Repair Instructions >> Accelerator Pedal with Position Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the insulator panel. Refer to Knee Bolster, Insulator, Molding Replacement - Instrument Panel .
  2. Remove the electrical connector position assurance (CPA) clip.
    3. Fig 1: Disconnecting Accelerator Pedal Position Sensor Electrical Connector
    GM1544734Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the accelerator pedal position sensor electrical connector.
  4. Remove the accelerator mounting bolts (1) from the accelerator bracket.
  5. Remove the accelerator assembly (2) from the vehicle.
scientia non olet · About LEMON Manuals