LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 178 (Interior Trim) >> Repair Instructions >> Trim Panel Replacement - Rear Quarter - Left >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Left Rear Quarter Trim Panel
    GM1552175Courtesy of GENERAL MOTORS CORP.
  1. Install rear quarter trim panel to vehicle.
  2. Feed the seat belts through the openings in the trim panel.
  3. Install the rear quarter trim retainers by aligning the retainer with the holes and then pushing the retainers to secure.
  4. Install the upper cargo net retainers.
  5. Install the liftgate sill plate. Refer to Door Sill Plate Replacement - Liftgate .
  6. Install the seat belt anchor retaining bolts. Refer to Seat Belt Retractor Replacement - Rear (LWB w/RPO E59) or Seat Belt Retractor Replacement - Rear (SWB) .
    7. Fig 2: Removing/Installing Rear Seat Belt Escutcheons
    GM1552103Courtesy of GENERAL MOTORS CORP.
  7. Install the rear seat belt escutcheons.
  8. Install the rear upper finish panel trim. Refer to Trim Panel Replacement - Body Lock Pillar Upper .
  9. Install the rear upper finish panel trim. Refer to Finish Panel Replacement - Upper Rear Trim .
  10. Install the rear seats. Refer to Seat Replacement - Rear .
scientia non olet · About LEMON Manuals