LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 176 (Entertainment Systems) >> Repair Instructions >> Receiver Replacement - Digital Radio >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Knee Bolster Assembly
    GM318206Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not exchange digital radio receivers between vehicles. Exchanging digital receivers between vehicles will activate the digital radio Theftlock. "XM Theftlock" will be displayed.
  1. Remove the left instrument panel (I/P) insulator. Refer to Knee Bolster, Insulator, Molding Replacement - Instrument Panel in Instrument Panel, Gages and Console.
    2. Fig 2: View Of Radio Wiring Harness
    GM955738Courtesy of GENERAL MOTORS CORP.
  2. Remove the receiver bracket nuts.
  3. Remove the receiver from the bracket.
  4. Disengage the electrical connector and the antenna connectors from the XM radio receiver.
    5. Fig 3: Identifying XM Digital Radio Receiver
    GM955754Courtesy of GENERAL MOTORS CORP.
  5. Remove the XM digital radio receiver from the vehicle.
scientia non olet · About LEMON Manuals