Removal Procedure
WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the antenna mast from the base.
- Unscrew the locking nut from the base in order to release the base from the fender.
- Remove the instrument panel insulator. Refer to Knee Bolster, Insulator, Molding Replacement - Instrument Panel in Instrument Panel, Gages and Console.
- Remove the cowl side trim panel. Refer to Trim Panel Replacement - Cowl Side in Interior Trim.
- Disconnect the antenna cable from the antenna extension lead.
- Cable is in a harness wrapped in blue tape. Note the routing of the cable.
- Remove the antenna base and cable assembly from the vehicle.