LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 176 (Entertainment Systems) >> Repair Instructions >> Coaxial Cable Replacement - Digital Radio >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Coaxial Cable
    GM914898Courtesy of GENERAL MOTORS CORP.
  1. Remove the headliner. Refer to Headliner Replacement in Interior Trim.
  2. Disconnect the antenna cable from the antenna base cable connector.
  3. Remove the retainer clips from the antenna cable.
  4. Remove the right instrument panel (I/P) insulator. Refer to Knee Bolster, Insulator, Molding Replacement - Instrument Panel .
    5. Fig 2: Locating Cable Connectors Inside Of Instrument Panel (I/P)
    GM1132274Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the cable connectors.
    6. Fig 3: Identifying XM Digital Radio Receiver
    GM955754Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the antenna cable from the digital radio receiver.
  7. Remove the antenna cable retainers from the receiver bracket.
  8. Remove the right windshield pillar garnish molding. Refer to Garnish Molding Replacement - Windshield Pillar .
  9. Remove the antenna cable.
scientia non olet · About LEMON Manuals