Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Coaxial Cable

Courtesy of GENERAL MOTORS CORP.

Install the antenna cable retainers to the receiver bracket.
Install the right windshield pillar garnish molding. Refer to Garnish Molding Replacement - Windshield Pillar .

Fig 2: Identifying XM Digital Radio Receiver

Courtesy of GENERAL MOTORS CORP.

Connect the antenna cable to the digital radio receiver.

Fig 3: Locating Cable Connectors Inside Of Instrument Panel (I/P)

Courtesy of GENERAL MOTORS CORP.

Install the cable connectors.
Install the right I/P insulator. Refer to Knee Bolster, Insulator, Molding Replacement - Instrument Panel .

Fig 4: View Of Antenna Base Assembly

Courtesy of GENERAL MOTORS CORP.

Install the antenna cable retainer clips.
Connect the antenna cable to the antenna base cable connector.
Install the headliner. Refer to Headliner Replacement in Interior Trim.