Conditions for Clearing the DTC

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.

The ECM will command the message OFF after one trip in which the diagnostic test has been run and passed.
The history DTC will clear after 40 consecutive warm-up cycles have occurred without a malfunction.
The DTC can be cleared by using the scan tool Clear DTC Information function.

DTC P0562

Step	Action	Value(s)	Yes	No
Schematic Reference: Engine Controls Schematics in Engine Controls - 3.6L (LY7) Connector End View Reference: Engine Control Module (ECM) Connector End Views in Engine Controls - 3.6L (LY7) or Power and Grounding Connector End Views in Wiring Systems
1	Did you perform the Diagnostic System Check - Vehicle?	-	Go to Step 2	Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2	Install a scan tool. Start the engine. Raise the engine speed above 1,500 RPM. With a scan tool, observe the Ignition 1 Signal parameter in the engine control module (ECM) data list. Does the scan tool indicate that the Ignition 1 Signal parameter is greater than the specified range?	10.5 V	Go to Step 6	Go to Step 3
3	Using a scan tool, compare the Battery Voltage Signal parameter in the body control module (BCM) data list with the Ignition 1 Signal parameter in the ECM data list. Are the Battery Voltage and Ignition 1 Signal parameter readings different by more than the value specified?	0.5 V	Go to Step 4	Go to Charging System Test
4	Test the battery positive voltage circuit of the ECM for a high resistance. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition?	-	Go to Step 7	Go to Step 5
5	Inspect for poor connections at the harness connector of the ECM. Refer to Testing for Intermittent Conditions and Poor Connections andConnector Repairs in Wiring Systems. Did you find and correct the condition?	-	Go to Step 7	Go to Step 6
6	IMPORTANT: The replacement ECM must be programmed. Replace the ECM. Refer to Control Module References in Computer/Integrating Systems for replacement, setup and programming.Did you complete the replacement?	-	Go to Step 7	-
7	Review and record the scan tool Failure Records data. Use the scan tool in order to clear the DTC. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text. Using the scan tool, observe the Specific DTC Information for DTC P0562 until the test runs. Does the scan tool indicate that DTC P0562 failed this ignition?	-	Go to Step 2	System OK