LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 106 (Seat System) >> Repair Instructions >> Seat Back Heater Element Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Front Seat Back Heater Element & Electrical Connector
    GM1466651Courtesy of GENERAL MOTORS CORP.
  1. Peel off the self-stick tape from the heater element.
  2. Position the heater element over the seat back. Press firmly to engage the adhesive.
  3. Route and connect the electrical connector to the seat back cushion. Secure the wire with tie straps.
  4. Install the seat back cover. Refer to Seat Back Cover Replacement - Front .
  5. Install the front seat. Refer to Seat Replacement - Front Bucket .
scientia non olet · About LEMON Manuals