LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Body Rear End) >> Repair Instructions >> Pressure Relief Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the rear compartment.
  2. Remove the rear bumper fascia. Refer to Fascia, Bracket, Bar, Absorber Replacement - Rear Bumper in Bumpers.
  3. Pull back the right rear compartment trim panel as needed. Refer to Compartment Trim Panel Replacement - Rear .
  4. Use a small, flat-bladed tool to release the snaps on the pressure relief valve. Apply pressure at two upper locations and two lower locations.
    5. Fig 1: Pressure Relief Valve
    GM318859Courtesy of GENERAL MOTORS CORP.
  5. Remove the pressure relief valve from the lower quarter panel.
scientia non olet · About LEMON Manuals