LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Body Rear End) >> Repair Instructions >> Pressure Relief Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Pressure Relief Valve
    GM318859Courtesy of GENERAL MOTORS CORP.
  1. Install the pressure relief valve in the lower quarter panel.
  2. Press the pressure relief valve into the quarter lower panel until the snaps lock into place at the upper and lower locations.
  3. Install the rear compartment trim panel. Refer to Compartment Trim Panel Replacement - Rear .
  4. Install the rear bumper fascia. Refer to Fascia, Bracket, Bar, Absorber Replacement - Rear Bumper in Bumpers.
  5. Close the rear compartment.
scientia non olet · About LEMON Manuals