LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Hood Latch Release Cable Replacement >> Removal Procedure

Removal Procedure

  1. Open the hood.
  2. Remove the hood latch. Refer to Hood Latch Replacement .
    3. Fig 1: Replacing Hood Latch Release Cable
    GM1613472Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the hood release cable (1) from the hood latch (2).
  4. Disconnect the hood release cable from the hood release handle.
  5. Tie a piece of string around the hood release cable. This will ease the installation of the hood release cable through the passenger compartment.
    6. Fig 2: Removing/Installing Hood Release Cable Grommet From Dash Panel
    GM1613475Courtesy of GENERAL MOTORS CORP.
  6. Remove the hood release cable grommet (1) from the dash panel.
  7. Note routing of cable.
  8. Remove the hood release cable from the vehicle.
scientia non olet · About LEMON Manuals