High Beam Indicator Inoperative (with Intellibeam)

Step	Action	Yes	No
Schematic Reference: Headlights/Daytime Running Lights (DRL) Schematics Connector End View Reference: Master Electrical Component List
1	Did you perform the Diagnostic System Check - Vehicle?	Go to Step 2	Go to Diagnostic System Check - Vehicle
2	Do the high beam headlamps operate properly?	Go to Step 3	Go to Headlamps Inoperative - High Beams
3	Does the high beam indicator located on the instrument panel cluster (IPC) illuminate when the headlamp dimmer switch is cycled to the high beam position?	Go to Step 4	Go to Step 6
4	Test the headlamp automatic high beam DIM status circuit for an open, high resistance, or short. Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition?	Go to Step 9	Go to Step 5
5	Inspect for poor connections at the harness connector of the inside rearview mirror (ISRVM). Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs . Did you find and correct the condition?	Go to Step 9	Go to Step 8
6	Inspect for poor connections at the harness connector of the IPC. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs . Did you find and correct the condition?	Go to Step 9	Go to Step 7
7	Replace the IPC. Refer to Control Module References for replacement, setup, and programming. Did you complete the replacement?	Go to Step 9	-
8	Replace the ISRVM. Refer to Control Module References for replacement, setup, and programming. Did you complete the replacement?	Go to Step 9	-
9	Operate the system in order to verify the repair. Did you correct the condition?	System OK	Go to Step 2