LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 3.6L - 1 Of 5) >> On-Vehicle Repair Instructions (1 Of 2) >> Camshaft Replacement - Right Side >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the upper intake manifold with the lower intake manifold. Refer to Lower Intake Manifold Replacement .
  2. Remove the camshaft cover. Refer to Camshaft Cover Replacement - Right Side .
  3. Remove the camshaft sensors. Refer to Camshaft Position Sensor Replacement - Bank 1 (Right Side) Exhaust and Camshaft Position Sensor Replacement - Bank 1 (Right Side) Intake .
  4. Remove the intake camshaft position actuator solenoid. Refer to Camshaft Position Actuator Solenoid Replacement - Bank 1 (Right Side) Intake .
  5. Remove the crankshaft balancer. Refer to Crankshaft Balancer Removal .
    6. Fig 1: Identifying Camshaft Neutral (Low Tension) Position
    GM1306310Courtesy of GENERAL MOTORS CORP.
  6. Rotate the crankshaft with the EN 46111  until the camshafts are in a neutral (low tension) position. See Special Tools . The camshaft flats will be parallel with the camshaft cover rail (1).
    7. Fig 2: Preventing Camshaft/Engine Rotation Using Open-End Wrench
    GM1340931Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Torque Reaction Against Timing Drive Chain Notice .
    IMPORTANT:
    • Use an open-end wrench at the camshaft hex to prevent camshaft/engine rotation.
    • DO NOT remove the camshaft position actuator bolt at this time.
  7. Loosen the camshaft position actuator bolt.
    8. IMPORTANT: Ensure that the tips of the EN 46108  are fully engaged into the timing chain (3 and 4). See Special Tools .
    Fig 3: Identifying EN 46108
    GM1341287Courtesy of GENERAL MOTORS CORP.
  8. Install the EN 46108  (1 and 2) in order to retain the timing chain. See Special Tools .

    Firmly tighten the EN 46108  nuts. See Special Tools .

    9. Fig 4: Identifying Timing Chain Marks And Their Respective Locations On Gears, Sprockets And Actuators
    GM1306457Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Ensure that the camshaft timing chain and the camshaft position actuators are marked for proper assembly.
  9. Mark the timing chain and the respective locations on camshaft position actuators (15-18).
  10. Remove the camshaft position actuator bolt.
  11. Remove the camshaft bearing caps and the camshaft. Refer to Camshaft Removal - Right Side .
scientia non olet · About LEMON Manuals