LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Mechanical - 3.6L - 2 Of 5) >> On-Vehicle Repair Instructions (2 Of 2) >> Oil Pan Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the powertrain module from the vehicle and install the engine to an engine stand. Refer to Engine Replacement .
  2. Remove the A/C compressor with the hoses from the engine. Refer to Air Conditioning (A/C) Compressor Removal .
  3. Remove the engine front cover. Refer to Engine Front Cover Replacement .
    4. Fig 1: Locating Oil Pan
    GM1394086Courtesy of GENERAL MOTORS CORP.
  4. Remove the oil pan. Refer to Oil Pan Removal .
  5. Perform the following steps as necessary.
    1. Disassemble the oil pan. Refer to Oil Pan Disassemble
    2. Clean and inspect the oil pan. Refer to Oil Pan Cleaning and Inspection .
scientia non olet · About LEMON Manuals