LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Wiper System & Washer System) >> Repair Instructions >> Wiper Motor Crank Arm Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
    2. Fig 1: Identifying Wiper Transmission & Wiper Motor Crank Arm
    GM306506Courtesy of GENERAL MOTORS CORP.
  2. Using the J 39232  , disconnect the wiper transmission from the wiper motor crank arm.
    3. Fig 2: View Of Wiper Motor Crank Arm Cover & Screw
    GM334250Courtesy of GENERAL MOTORS CORP.
  3. Remove the wiper motor crank arm cover.
  4. Remove the wiper motor crank arm screw.
  5. Remove the wiper motor crank arm from the wiper motor.
scientia non olet · About LEMON Manuals