LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (Rear Suspension System) >> Repair Instructions >> Wheel Stud Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Washers, Wheel Stud & Hex Nut
    GM65317Courtesy of GENERAL MOTORS CORP.
  1. Install the replacement bolt 3) in the wheel hub.
  2. Add enough washers (1) to draw the bolt into the hub.
    3. NOTE: Refer to FASTENER NOTICE .
    IMPORTANT: Seat the wheel bolt fully against the hub flange.
  3. Install the wheel nut (2) with the flat side to the washers.

    Tighten:  Tighten the wheel nut until the wheel bolt head seats against the hub flange.

  4. Back off the wheel nut.
  5. Remove the washers.
  6. Install the rotor. Refer to Rear Brake Rotor Replacement .
  7. Install the brake caliper and bracket. Refer to Rear Brake Caliper Bracket Replacement .
  8. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  9. Lower the vehicle.
scientia non olet · About LEMON Manuals