LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (Rear Suspension System) >> Repair Instructions >> Rear Wheel Bearing and Hub Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Backing Plate & Wheel Bearing/Hub
    GM1228560Courtesy of GENERAL MOTORS CORP.
  1. Install the backing plate (2) and the wheel bearing hub (3).
    2. NOTE: Refer to Fastener Notice .
  2. Install the wheel bearing/hub-to-knuckle bolts.

    Tighten:  Tighten the bolts to 75 N.m (55 lb ft).

    3. Fig 2: Rear Wheel Speed Sensors Component View
    GM305363Courtesy of GENERAL MOTORS CORP.
  3. Install the ABS electrical connector to the wheel speed sensor (1), if equipped.
  4. Install the brake rotor and caliper. Refer to Rear Brake Rotor Replacement .
  5. Install the tires and wheels. Refer to Tire and Wheel Removal and Installation .
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals