LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Wiring Systems And Power Management - Introduction) >> Repair Instructions >> Instrument Panel Electrical Center or Junction Block Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Body Wiring Harness & Accessory Wiring Junction Block Bolt
    GM928964Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (L26) or Battery Negative Cable Disconnection and Connection (LY7) or Battery Negative Cable Disconnection and Connection (LS4) .
  2. Remove the outer trim cover. Refer to Instrument Panel Outer Trim Cover Replacement .
  3. Disconnect the body wiring harness from the accessory wiring junction block. Pull the harness away from the block for access.
  4. Remove the instrument panel (I/P) compartment. Refer to Instrument Panel Compartment Replacement .
  5. Remove the junction block bolt.
    6. Fig 2: Identifying Junction Block Tabs & Passenger Knee Bolster
    GM929411Courtesy of GENERAL MOTORS CORP.
  6. Disengage the junction block tabs from the passenger knee bolster. Pull the junction block away from the I/P.
  7. Remove the junction block.
scientia non olet · About LEMON Manuals