LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 32 (Power Steering System) >> Repair Instructions >> Power Steering Pump Pulley Replacement (L26) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Power Steering Pump Assembly
    GM293353Courtesy of GENERAL MOTORS CORP.
  1. Using J 25033-C  install the power steering pump pulley to the power steering pump.
    2. Fig 2: Measuring Axial Tolerance Of Power Steering Pulley On Pump
    GM254752Courtesy of GENERAL MOTORS CORP.
    IMPORTANT:
    • Never use a hammer to install the power steering pulley.
    • The face of the power steering pulley hub must be flush to within 0.25 mm (0.010 in) with the end of the power steering pump driveshaft.
  2. Install the power steering pump to the engine. Refer to Power Steering Pump Replacement (L26)  or Power Steering Pump Replacement (LY7)  or Power Steering Pump Replacement (LS4) .
  3. Fill the power steering system. Refer to Checking and Adding Power Steering Fluid .
  4. Bleed the power steering system. Refer to Power Steering System Bleeding .
  5. Inspect the power steering system for leaks. Refer to Power Steering Fluid Leaks .
scientia non olet · About LEMON Manuals