LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Front Suspension System) >> Repair Instructions >> Wheel Stud Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  3. Remove the brake caliper and bracket. Hang the caliper and the bracket from the vehicle. DO NOT allow the caliper and the bracket to hang by the brake hose. Refer to Front Brake Caliper Replacement .
  4. Remove the brake rotor. Refer to Front Brake Rotor Replacement .
    5. Fig 1: Extracting Stud From Hub
    GM144028Courtesy of GENERAL MOTORS CORP.
  5. Use the J 6627-A  in order to extract the stud (1) from the hub (2). See Special Tools .
scientia non olet · About LEMON Manuals