LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Front Suspension System) >> Repair Instructions >> Front Lower Control Arm Bushing Replacement (Vertical) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the lower control arm. Refer to Lower Control Arm Replacement .
  2. Secure the lower control arm in a vice.
    3. Fig 1: Scribing Orientation Of Control Arm Bushing On Lower Control Arm
    GM381812Courtesy of GENERAL MOTORS CORP.
  3. Mark the lower control arm along the flat edge of the bushing flange.
    4. Fig 2: Assembling Bushing Removal Tools
    GM381816Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Apply J 23444-A  or equivalent to the threads of J 21474-27  . See Special Tools .
  4. Assemble the following bushing removal tools as shown:
    1. J 21474-27 
    2. J 21474-13  . See Special Tools .
    3. J 34126  . See Special Tools .
    4. J 35379  . See Special Tools .
    5. J 21474-2  . See Special Tools .
    6. J 21474-4 
  5. Tighten J 21474-4  .
  6. Disassemble the bushing removal tools.
scientia non olet · About LEMON Manuals