LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Front Suspension System) >> Repair Instructions >> Front Lower Control Arm Bushing Replacement (Horizontal) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the lower control arm. Refer to Lower Control Arm Replacement .
  2. Secure the lower control arm in a vise.
    3. Fig 1: Assembling Bushing Removal Tools
    GM1171032Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Use a 1/2 x 20 in standard thread nut with the puller bolt.
  3. Assemble the bushing removal tools as indicated:
    1. The nut (1)
    2. The J 21474-01  washer (2). See Special Tools .
    3. The J 21474-01  bearing (3). See Special Tools .
    4. The J 21474-5  (4). See Special Tools .
    5. The J 21474-01  puller bolt (5). See Special Tools .
  4. Tighten the puller bolt (5) until the bushing is removed.
  5. Disassemble the J 21474-01  and J 21474-5  . See Special Tools .
scientia non olet · About LEMON Manuals