Removal Procedure
WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
- Pull back the rear compartment trim as required to access the lock striker. Refer to Rear Compartment Trim Panel Replacement .
- Use a grease pencil to mark the location of the lock striker to the rear compartment for its location at installation.
- Remove the bolt from the rear compartment lid lock striker in the rear compartment.
- Remove the rear bumper fascia. Refer to Rear Bumper Fascia Replacement .
- Remove the rear compartment lid lock striker bolts from under the rear bumper fascia above the impact bar to the body panel.
- Remove the rear compartment lid lock striker from the rear compartment body panel.